Author Topic: Back To Coova-AP firmware  (Read 5252 times)

Offline nehasofttact

  • Jr. Member
  • **
  • Posts: 15
Back To Coova-AP firmware
« on: April 28, 2016, 07:48:45 am »
Hi, I would like to know how to return the router from Worldspot firmware to Coova-AP firmware.

Thanks,

Neha

Offline WorldSpot

  • Administrator
  • Hero Member
  • *****
  • Posts: 2472
Re: Back To Coova-AP firmware
« Reply #1 on: April 28, 2016, 08:57:06 am »

Offline nehasofttact

  • Jr. Member
  • **
  • Posts: 15
Re: Back To Coova-AP firmware
« Reply #2 on: April 30, 2016, 06:49:02 am »
Hii,
I tried the steps you mentioned but still the firmware is not been removed. Please suggest any other solution.
Thanks.

Offline WorldSpot

  • Administrator
  • Hero Member
  • *****
  • Posts: 2472
Re: Back To Coova-AP firmware
« Reply #3 on: April 30, 2016, 08:30:41 am »
What is your router? Have you killed some processes to free memory?
You may have to flash a small firmware before coova ap.

Is there a problem with worldspot firmware? Which version did you try?

Offline nehasofttact

  • Jr. Member
  • **
  • Posts: 15
Re: Back To Coova-AP firmware
« Reply #4 on: May 02, 2016, 08:10:37 am »
Hii,

Router Model - WRT54GL
Platform- Broadcom BCM47XX
Firm Vers- trunk-31059-4

I want to remove the firmware and fix it back as it was before the worldspot firmware installation.

Thanks.

Offline nehasofttact

  • Jr. Member
  • **
  • Posts: 15
Re: Back To Coova-AP firmware
« Reply #5 on: May 03, 2016, 06:22:29 am »
Hello Sir,

  But I forgot admin username & Password.So I created new user when I am executing this steps, It shows error "Action result
Please authenticate first"


 I executed this commands,

lanIfName=$(uci get network.lan.ifname)
wanIfName=$(uci get network.wan.ifname)

echo old config : lan: $lanIfName wan: $wanIfName
echo ---------------
uci show network
if [ "$lanIfName" != "" ] && [ "$wanIfName" != "" ]
then
  echo
  echo switching interfaces
  uci set network.lan.ifname="$wanIfName"
  uci set network.wan.ifname="$lanIfName"
  echo new config:
  echo ---------------
  uci show network
  echo
  echo 'if ok, please send these commands "uci commit network;reboot"'
fi

Offline WorldSpot

  • Administrator
  • Hero Member
  • *****
  • Posts: 2472
Re: Back To Coova-AP firmware
« Reply #6 on: May 03, 2016, 07:40:45 am »
These are not for flashing. Please read the second part of the topic which is the flashing procedure.

 

anything